Funcart comin along

Buggy Specific

Funcart comin along

Postby ryan85 » Tue Oct 13, 2009 10:21 pm

hey managed to get my sprockets mounted up and my radiator today just about ready to weld up all my frame properly its been a pain fitting this motor up. i think im gonna move my steering setup in front of my front axle so i have more leg room though its pritty tight at the moment. Iv found a place called statewide bearings in welshpool they have heaps if sprockets and pulleys ect. i got 2 14 t and a 57 t sprocket (half inch pitch )they come with a pilot hole in the center so u can make them fit what u want, there cheap too $10 for the small ones and $50 for the bigger ones. i also found a engineering shop close by that can cut internal key ways getting my hubs, sprocket and axle done for $150 .
anyway here are a couple more pics
13102009.jpg (201.24 KiB) Viewed 3756 times
13102009(001).jpg (225.99 KiB) Viewed 3756 times
Registered Member
Posts: 9
Joined: Sat Oct 10, 2009 2:46 am

Re: Funcart comin along

Postby burke_a_lot » Thu Oct 29, 2009 9:27 am

looks like you got yourself one fine looking kart.... well almost.... like the setup.... tops!
"It does not matter what you drive.... it's the driver that wins the race...." Quote by William Butcher
User avatar
Registered Member
Posts: 2
Joined: Wed Oct 28, 2009 7:48 pm
Location: Booroorban

Return to Raven / Fun Kart III / Trax II

Who is online

Users browsing this forum: No registered users and 1 guest